First,
the Lil’ Mynx is removable. The pole itself does not
bolt to the floor or ceiling. The ceiling mount does require
1 bolt into a joist which can be found using a stud finder.
The Pro Pole comes with a friction ceiling mount that does
not require a bolt into the ceiling, although you must still
find a joist to straddle. Keep in mind this is held in place
by friction and cannot withstand as large a side load as
the bolted mount.
The removable nature of our product offers the flexibility
of only having the Lil' Mynx in place when you want to use
it. You regain the space in your room when the pole is not
in use. You can simply store the Lil' Mynx under your bed,
behind the couch, or in a closet when finished. If you prefer,
the Lil’ Mynx can easily be made permanent by securing
the base to the floor with screws (not included) instead
of using the rubber feet included.
Second,
our line of dance poles are 2 inch OD and come standard
to adjust in length to be used with a 2.4 – 3 metre
ceiling. The main body of the pole is approximately 2.4
metres on all poles. This is the useable dance area of the
pole. The slider tube, the smaller adjustable tube that
couples the ceiling mount, can never be used as a part of
the dance area.
Third,
you have the choice between the Original Lil’ Mynx,
that is a stationary removable dance pole, the Lil’
Mynx “Rotator”, that is a combination spinning/stationary
removable dance pole or the Lil’ Mynx Pro Pole, that
is a 2-piece stationary removable dance pole.
The “Rotator” has a smart designed bearing
assembly in the base that allows the pole to rotate freely.
It also has a lockout pin that will lock the pole into place
and make the pole stationary when desired. It’s like
2 poles in 1! Other than the bearing assembly and lockout
pin both poles share the same installation and quality features.
The Pro Pole is a 2-piece stationary design with a handy
carrying case for use from 2.4 – 3 metre ceilings.
The accessories included are bolted ceiling mount, friction
ceiling mount, non-skid floor pad, stud finder and tape
measure. This pole is fully portable!
Fourth,
while the Lil’ Mynx was designed with carpeted floors
in mind we offer a small pad for use on non-carpeted floors
as well, including hardwood, tile, cement, etc.
The Lil’ Mynx is very easy to install. It takes
less than 10 minutes for the initial installation and weighs
a mere 9 kilos. Our simple design incorporates a unique
ceiling mount, disguised as a plant hook for discretion,
that requires only a single screw into a main joist in the
ceiling. A threaded compression system holds the Lil’
Mynx in place. It can handle a person up to 110 kilos. When
the pole is put away all you have left is a functional plant
hook in the ceiling. After initial installation it takes
only seconds to put up or take down, with no tools needed.
|
|
